SCM and Morbidelli
Four kinds of work, all done by the same engineer. Pick the one you need, or ring and tell me what's happening.
Breakdowns
Tell me the make, the model and what it's doing, or what's on the screen. If it's a setup or software problem we can often clear it on the phone there and then.
If it needs hands on it, I come out, find the fault and tell you what it is and what it will cost before I start. Then it's repaired, recalibrated and run before I leave.
Servicing
Most breakdowns give you a warning first: a bit of play, a drift in accuracy, a noise that wasn't there last month. A service is where those get found.
Lubrication, alignment and calibration, belts and drives, electrical checks, emergency stops and guarding. Anything worn gets shown to you, so you can decide before it decides for you.
A service£500
Ring about servicing07904 610916Installs
A new machine, a second-hand one, or one that's moving across the workshop. I take the old one out of service properly, put the new one in and commission it to the manufacturer's guidelines.
While I'm at it you get a condition report: anything I find, and how soon it matters.
Training
Training is done on the machine you own, with the work you actually run, so your operators are producing as soon as possible.
I also give CAD/CAM support for SCM and Morbidelli machining centres. Other machines on request.
Other makes
Some of the machines in the photos on this site are made by Hua Hua and imported from China. I supply them, and I support them once they're running.
I also support other makes that use Syntec controllers. If that's what is on your machine, ring me with the make and model.
Four things that save time on the phone and, more often than you'd think, save the visit.
01
It's on the plate on the machine.
02
Or the error on the screen, word for word.
03
And anything that changed just before.
04
So I can tell you when I can be there.
Keeping your machines running strong
